English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
WARNING
Do not attempt to modify this product or create ac-
cessories not recommended for use with this prod-
uct. Any such alteration or modication is misuse and
could result in a hazardous condition leading to pos-
sible serious personal injury.
WARNING
To prevent accidental starting that could cause seri-
ous personal injury, always remove the battery pack
from the product when assembling parts.
HANDLE ASSEMBLY (See figure 4)
Remove the battery pack.
Align the holes on the middle handle and the lower
handle. Insert the bolts, and use the handle knobs
to tighten them.
Align the hole on the middle handle and the upper
handle. Insert the cam locks and tighten them with
the handle knobs provided. Once tightened, close
the cam locks to secure them in place.
Note: If the upper handle is loose or separated from the
middle handle, tighten the cam lock handle knobs by
turning them clockwise. Do not overtighten the handle
knobs.
DISCHARGE CHUTE ADJUSTMENT HANDLE AS-
SEMBLY (See figure 5-6)
Align the holes on the upper chute control rod with
the holes on the lower chute control rod.
Insert the spring pin in the hole and fasten.
Insert the end of the chute control rod through the
keyed hole in the bracket that is attached to the top
of the middle handle.
Insert the end of the handle in the specific coupling
hole on the chute, keeping it straight and with the
grip upwards.
Check the discharge chute by turning it entirely in
both directions. The chute must freely rotate.
DEFLECTOR ASSEMBLY (See figure 7)
Push the chute deflector until the latching tabs on
both sides click into the slots and the posts on both
sides click into the keyed holes.
ASSEMBLY
UNPACKING
This product requires assembly.
Carefully remove the product and any accessories
from the box. Make sure that all items listed in the
packing list are included.
WARNING
Do not use this product if any parts on the Packing
List are already assembled to your product when you
unpack it. Parts on this list are not assembled to the
product by the manufacturer and require customer
installation. Use of a product that may have been im-
properly assembled could result in serious personal
injury.
Inspect the product carefully to make sure no
breakage or damage occurred during shipping.
Do not discard the packing material until you have
carefully inspected and satisfactorily operated the
product.
If any parts are damaged or missing, please call your
Greenworks Tools service centre for assistance.
PACKING LIST
Snow thrower
Upper chute control rod
Lower chute control rod
Middle handle assembly
Chute deflector
Cam locks
Bolts
Handle knobs
Spring pin
Ignition key
Owner's Manual
WARNING
If any parts are damaged or missing do not operate
this product until the parts are replaced. Use of this
product with damaged or missing parts could result
in serious personal injury.
Pridružite se pogovoru o tem izdelku
Tukaj lahko delite svoje mnenje o Greenworks GD40ST Snežna freza. Če imate vprašanje, najprej natančno preberite priročnik. Zahtevo za priročnik lahko opravite z uporabo našega kontaktnega obrazca.