IM010
www.scarlett.ru SC-1139S
4
GB INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
• Please read the instruction manual before use and
save it for future references.
• Before the first switching on check that voltage
indicated on the rating label corresponds to the
mains voltage in your home.
• For home use only. Do not use for industrial
purposes. Use the steam iron only for its intended
use.
• Do not use outdoors or in damp area.
• Do not immerse the steam iron and cord in water or
other liquids.
• Never pull the cord while disconnecting from the
power outlet; instead, grasp the plug only and pull
to disconnect.
• Do not allow the cord to touch sharp edges and hot
surfaces.
• Always unplug the steam iron from the power
supply when filling with water or emptying and
when not in use.
• Do not operate the steam iron with damaged cord
or plug, or after the appliance malfunctions, or has
been dropped or damaged in any manner. To avoid
risk of electric shock, do not disassemble the
steam iron; take it to a service center for
examination, repair or mechanical adjustment.
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given
supervision or instruction concerning use of the
appliances by a person responsible for their safety.
• Children should be supervised to ensure that they
do not play with the appliance.
• Do not leave the iron unattended while hot or
connected or on an ironing board.
• If ironing is interrupted, stand the iron on heel rest
only, do not place the steam iron on metal or rough
surfaces.
• CAUTION: To avoid a circuit overload, do not
operate another high wattage appliance on the
same circuit.
• If the product has been exposed to temperatures
below 0ºC for some time it should be kept at room
temperature for at least 2 hours before turning it
on.
• The manufacturer reserves the right to introduce
minor changes into the product design without prior
notice, unless such changes influence significantly
the product safety, performance, and functions.
BEFORE THE FIRST USE
• Some parts of the steam iron have been slightly
greased and as a result the iron may slightly smoke
when switched on for the first time. After a short
time this will cease.
• Remove protection cover from the soleplate and
clean it with a soft cloth.
HOW TO USE
SETTING TEMPERATURE
• Always check whether a label with ironing
instructions is attached to an article to be ironed.
Follow these instructions in all cases.
• Turn the temperature control dial round to set the
appropriate temperature indicated in ironing
instructions or on fabric label.
LABEL TYPE OF TEXTILE
Do not iron this article
• Synthetics, Nylon, Acrylics,
Polyester, Rayon
••
Wool, Silk
••• Cotton, Linen
Maximum temperature
(Steam)
• Insert the mains plug into the wall socket. The
indicator light will turn on.
• When the indicator light goes out you may start
ironing
• If you set the temperature control to lower setting
after ironing at a high temperature, it is not
recommended to iron before the pilot light switches
on again.
WATER TANK FILLING
• Unplug the iron before filling the water tank.
• Hold the steam iron in horizontal position.
• Slowly pour water through the water inlet.
• Do not fill higher than mark on the water tank, in
order to avoid water spilling.
• The opening which is used for pouring water
should be closed when the iron is in use.
• Always unplug the iron from the power socket
when refilling the water reservoir.
NOTE: Your steam iron is designed to use tap water.
However, if the water is very hard, it is advisable to
use distilled water.
NOTE: Do not use chemically de-limed or perfumed
water.
NOTE: If you have too hard water,it is advisable to
use only distilled or demineralized water.
• The water tank should be emptied after each use.
NOTE: If you empty the water tank after the steam
iron has cooled down, set the steam iron in an
upright position on its heel rest, plug it in and set
the temperature control dial to the maximum
position, heat for 2 minutes. Unplug the steam iron
from the power supply.
SPRAYING
• As long as there is enough water in the water tank,
you may use the spray button at any temperature
setting during steam or dry ironing.
• Press the spray button several times to activate the
pump while you are ironing.
STEAM IRONING
• With the unit unplugged, fill the steam iron with
water.
• Stand the steam iron on its heel rest in an upright
position on an iron-safe surface and plug in.
• Set the temperature control dial to the “••“ or “•••”
position.
• Set the variable steam control to the desired
position 1-4.
WARNING: The iron gives off steam continuously
only if you hold the iron horizontally. You can stop
the continuous steam by placing the iron in a
vertical position or by moving the steam selector to
“
”. To prevent water dripping steam function
available at the highest temperatures only.
CAUTION: Avoid coming in contact with ejected
steam.
Pridružite se pogovoru o tem izdelku
Tukaj lahko delite svoje mnenje o Scarlett SC-1139S Likalnik. Če imate vprašanje, najprej natančno preberite priročnik. Zahtevo za priročnik lahko opravite z uporabo našega kontaktnega obrazca.